Data Pack - Ko Propo Esprit-3 Universe Instruction Manual

20 20
Nine-model memory is the standard memory for this transmitter. However, it is possible to add another 16
model memories with the use of the Data Pack (option). The Data Pack is connected to the Multi Access
Port.
Using the Data Pack
The power switch of the transmitter should be OFF when detaching or attaching the Data Pack.
Slowly push it into the Multi Access Port of the transmitter.
(The connector pins on the transmitter can be damaged if inserted with force.)
The Data Pack will be recognized automatically if installed correctly.
However, it is necessary to format the Data Pack before it is used.
Please format it from the main menu under the 'FORMAT' function.
Format (initialization)
From the Main Menu ('ENTER' key form the initial
screen), use the Jog Dial, (+) or (-) keys to scroll
down to the end of the menu to find the 'FORMAT'
function. (Please note that this will not be displayed when the Data Pack is not in-
stalled.)
Pressing the 'ENTER' key while on the 'FORMAT' function, "DATA FORMAT?" will
be displayed. Move the cursor to YES and press the 'ENTER' key to start formatting.
The status of the format is displayed.
Once it has finished, 'COMPLETE' will flash on the screen. The screen will return to
the menu once any key is pressed.
You can confirm that the model memory has increased if "MODEL SELECT" (P30)
is selected from the function menu.
Please note that all content is deleted when Data Pack that has already
been formatted.
Note on Data Pack usage
Please note that all contents of the Data Pack will be deleted once it has been formatted.
The model memory in the Data Pack is displayed as a sign of the alphabet from A-P.
If it is necessary to remove the Data Pack and the model memory that is currently being
used is A-P, please return the model memory number to 1-9 before turning off the
transmitter and removing the Data Pack. Data Pack error will be displayed if the memory
was set to A-P and not installed. A model memory 0 will appear in its place.
The following are two methods of returning to the normal display.
The content of model memory 0 is a backup of the model memory that was
previously shown from the Data Pack.
Copy the content to the model memory currently displayed using the "MODEL
COPY" function (P51). The model memory will change to the assigned model
memory number.
The display of model memory 0 will not be possible to return to once you have
selected the "MODEL SELECT" function (P30). The content of the memory will
be lost. Please refer to Model Select (P30) for further details.
The 'BACK' key is pressed.

Data Pack

The 'ENTER' is pressed. Jog dial operation
[ . ] will be
increased
(+) and (-) keys are pressed. Pressing and holding simultaneously the (+) and (-) keys. (Reset)
blink " COMPLETE!! "
Model Memory A
Data Pack Error
Model Memory 0