Safety Notice - Ko Propo Esprit-3 Universe Instruction Manual

 
For the safe usage of this product
With the nature of radio control models, misoperation will result in danger.
In order to avoid these circumstances and to use this product safely, please read the contents thoroughly.
Explanation of warnings and signs
Meaning of icon indications
Prohibition
Notes before installing and using the equipment

Safety Notice

In this manual, the following warnings and signs should be noted carefully.
Failure to observe this matter discussed can lead to a serious threat of
Danger!
death or severe injury.
Failure to observe this matter discussed can lead to death or serious injury
Warning!
and a great likelihood of damaging the equipment or property.
Failure to observe this matter discussed can lead to injury or damage to the
Caution!
equipment or property.
Prohibited Matter
Not allowed to do.
Only use genuine KO PROPO crystal sets (transmitter and receiver).
Warning!
Other crystals may vary in frequency, which could lead to
Execution
misoperation or lose of control.
Prevent metal parts in the model (car or boat) from touching that may
Warning!
be caused by vibration.
Prohibition
This product is only designed for use with surface radio control models.
Warning!
Do not use this for any other purpose.
Prohibition
If a Ni-Cd battery pack is used in the transmitter, be sure to charge it
Warning!
properly before use.
Execution
If the batteries are not fully charged, the model may run out of control.
Be sure to connect all equipment correctly.
Warning!
If connections are loose, the model may run out of control.
Execution
Vibration may damage the servo and the model may run out of control.
Be sure to install the receiver with thick double-sided tape.
Warning!
A strong shock or vibration may result in the model running out of
Execution
control.
Do not cut or bundle the antenna wire of the receiver with other wires.
Warning!
This will result in decreasing the range of the receiver and may result
Prohibition
in the model running out of control.
After installing the servo, please verify its operation and that
Warning!
unreasonable power is not consumed.
Execution
Damaging the servo and the loss of power while connected will result
in the loss of control.
Be sure to use grommets on the servo to prevent it from directly
Warning!
touching any metal or carbon plates.
Execution
The vibration may damage the servo and the model may run out of
control.
Enforced Matter
This must be carried out!
Execution