Trim Rate - Ko Propo Esprit-3 Universe Instruction Manual

The operating quantity of one step of the trim is set.
The total number of operating steps is 100, but the operating quantity of one step is set.
[How to open the setup screen]
From the initial screen, use the Jog Dial, (+) or (-) keys to enter the function menu.
Using the Jog Dial, (+) or (-) keys, move the cursor in the menu list to "TRIM RATE" and press the 'ENTER'
key.
Use the Jog Dial, (+) or (-) keys to select the "ST" (steering) or "TH" (throttle) that you would like to modify
press the 'ENTER' key and you can set the respective channel.
The cursor returns to the beginning of the function if the 'ENTER' or 'BACK' key is pressed and pressing the
'BACK' key again will return you to the function menu list.
The operating quantity of one step of the trim value is set, but if the value is small the operating quantity
becomes small.
The number of total steps does not change when the trim rate is changed, but the range of correction of
that one step does change the trim rate.
If the trim has already been adjusted in the car and you change the trim rate, the setting may be off.
(Setting the trim rate to 0 will cause no changes in the trim when pressed.)
If the trim rate is set small the corrections will be small, but there are times when you
cannot obtain the correct effect depending on the servo.
If there is abnormal play in the linkage, servo saver, etc., small corrections in the trim may
not work properly. Please check the linkage first and then the other settings.
TRIM RATE (Trim Rate)
Initial value 10
Minimum 1
Maximum 20