Ko Propo Esprit-3 Universe Instruction Manual page 70

P.MIXING -1.2 (Program Mixing 1 & 2)
0
How to setup the Program Mixing.
Choose the mixing mode.
Move the cursor
The cursor changes to
made.
Setting of the master and slave channels.to * and setting changes can be made.
Setting of mixing rate
Set the quantity of the "OFFSET".
OFFSET (offset function) Set the center point (the point that a direction is replaced by) of mixing from the master channel for the slave channel.
As a result, you can use the trim for the slave servo.
The operating quantity of the trim for the master channel can be reflected on the slave channel by choosing "ON" or "OFF".
Setting of trim
Function Setting (FUNC)
to "MIX" and press the 'ENTER' key.
and setting changes can be
MST.CH (Master channel) ...
SLV.CH (Slave channel) ...
Also, it is possible to select an identical channel to the master channel and the slave
channel. At that time, the operational angle mixing rate (RATE) depends on the quantity.
You can change a set point in a range from -100% to +100%.
A setting of negative value operates the slave servo in the opposite direction of the master servo. A positive setting
value operates the slave in the same direction as the master.
The "RATE" is changed by appointment of the master channel.
When master servo is ST.
Upper tier: L (left)
Lower tier: R (right)
Move the cursor > to "OFFSET" and press the 'ENTER' key.
The cursor changes to * and the setting can be changed.
The setting can be changed from –100% to +100%.
OFF... Mixing is turned off.
MODE1... The mixing is applied from the input of
the Master channel of the stick and
BT or ET.
MODE2... The mixing is applied from the output
of the Master channel.
Move the cursor to "MST.CH" or "SLV.CH" and press the 'ENTER' key.
The cursor changes to and setting changes can be made.
This is the channel which applies the mixing that is
appointed.
Choices are ST (CH1), TH (CH2) or 3CH.
This is the channel which will have the mixing applied to
and is appointed.
Choices are the same as the Master ST, TH and 3CH.
Move the cursor > to "OFFSET" and press the 'ENTER' key. The
cursor changes to * and the setting changes can be made.
When master servo is TH.
Upper tier: F (Advance side)
Lower tier: B (Back side)
A set value can be changed within the range of -100 to +100%.
(ON) reflects the amount of operation of the trim not to be operated with the master
channel in the slave servo, (OFF) will not follow this rule and can be selected.
The functional effect that is set to the master channel can be reflected
to the slave channel by choosing "ON" or "OFF".
When master is 3Ch
Upper tier: + (Plus side)
Lower tier: - (Minus side)