Steering Travel Preset - Ko Propo Esprit-3 Universe Instruction Manual

This function can change the movement of steering servo to three phases that are set beforehand.
You can change the movement of steering servo by easily operating a lever even during run.
[How to open the setup screen]
It is possible to set it within the
range of 0~100%.
From initial screen, use Jog Dial, (+) or (-) keys to open the Function menu.
From the menu list, choose the "ST:TR PRSET" and press the 'ENTER' key.
Press the 'ENTER' key to enter the setup menu.
Use the Jog Dial, (+) or (-) keys to choose the adjusting SET1 - 3.
Press the 'ENTER' key to enter the setting SET1 - 3, use the Jog Dial, (+) or (-) keys to adjust the value.
When pressing the Enter key at SET1 - 3, the cursor changes
To reset to the factory default, press and hold simultaneously the (+) and (-) keys.
The display will show 100%.
You can adjust the value from 0 to +100. Pressing the 'ENTER' key, the cursor changes from
and is assigned.
You can change the SET1 to SET3 by operating a ST:TR PRESET Lever.
ST:TR PRESET Lever initialization is up for SET2, middle for SET1 and down
for SET3.
When settings are close to one another for SET 2, 1, 3, it is easy to operate it
intuitively and is convenient for prevention of false operation.
You can use this set up for low traction tracks or for Oval races.
ST:TR PRESET(Steering Travel Pre-setting)
to and then you can adjust the value.

to