Pairing (For General Receiver) - Ko Propo EX-RR Instruction Manual

● Pairing (For general receiver)
In order for the receiver to operate, it must store the
transmitter's unique ID in its memory in a process called
"pairing." Even if a single transmitter is uesd to control
multiple receivers, each receiver must go through the
pairing process with the transmitter before being used for
the first time.
※ Please adjust the modulation mode before pairing. (p.18)
A receiver does not work normally in a different mode.
1.
Preparing the Transmitter
① While pushing the ET2 lever up, power on.
The pilot LED lights up, release ET2 lever.
Power
ON
ET2
② Displays the initial screen, then pairing display is
shown. (indicating transmitter is transmitting the
pairing signal.)
<French mode pairing ＞
French mode pairing is possible when the ET2 lever is released after
LED turns off. Please use this feature if the situation is needed.
P
French mode pairing...
The FHSS communication pattern of the EX-RR
and receiver are modified. Please use the French
mode when the location of usage requires this
mode. When in any other location, please use the
general mode.
2.
Preparing the Receiver
① Connect the receiver power source
while pressing the setup button.
② Check that the receiver's LED
has lit up, then release the setup
button.
③ Check that the receiver's LED
lights up again (indicating pairing
completion)
3.
Preparations for Operation
① Switch off the receiver.
② Switch off the EX-RR main power,
then switch on EX-RR again.
③ Switch on the receiver and check
that the receiver LED is lit. If the
LED flashes, the receiver is not
getting the EX-RR signal and
＜ FHSS/General ＞
the pairing procedure should be
repeated.
During this process, your car may become uncontrollable
if the ESC has not been adjusted. As a precaution, set
your car so that its wheels do not touch the ground.
Pairing procedures may not go smoothly if there are wireless
LAN, microwave ovens, or other users conducting pairing
procedures nearby. In this case, move some distance away or
wait a while before attempting the pairing procedure again.
If the mode is changed（General or France), please
conduct pairing procedures with the receiver you are
using again.
④ Set the Fail-Safe Function（p.22）.
● For an Electric Car
● Steering Servo (CH1)
（Sold separately)
● For a Glow Engine Car
● Throttle Servo (CH2)
（Sold separately)
BATT
This transmitter is only compatible with digital servos.
Correct operation is not possible when used with analog
servos.
For items which are not included in this product, please
refer to the KO Propo website for a list of compatible
products. (http://www.kopropo.co.jp)
Lit LED
19
● Battery Pack
（Sold separately)
● Reciever
● Battery for Reciever
（Sold separately)
● Reciever
● Steering Servo (CH1)
（Sold separately)
Lit LED
Flashing LED
● Morter
（Sold separately)
● ESC (CH2)
（Sold separately)