Throttle High Point - Ko Propo Esprit-3 Universe Instruction Manual

TH HIPOINT (Throttle High Point)
0
Setting of only the throttle advancement side value.
Throttle maximum advancement side setting can be increased and decreased. In an electric car, the full throttle
adjustment is set and for a gas car, the setting for the carburetor to open fully is set.
[How to open the setup screen]
From the initial screen, use the Jog Dial, (+) or (-) keys to enter the function menu.
Using the Jog Dial, (+) or (-) keys, move the cursor in the menu list to "TH:HIPOINT".
Pressing the 'ENTER' key enters the menu and using the Jog Dial, (+) or (-) keys will change the value.
The maximum value of the throttle advancement side is adjusted and set. This allows for simple adjust-
ment for a gas car.
Setting a large value in a gas car creates excessive load to the servo if not set correctly and will dam-
age the servo.
Please verify and adjust accordingly with this setting and the linkage.
In an electric car, if the setting is too small the ESC may not recognize the setting and there is no
performance gain. Please try the setting first with the factory default setting of 100.
Please note that the minimum value is 0, but you will not get any movement from the throttle with this
setting.
Because the throttle trim is for the center trim and if the "TH:HIPOINT" setting is a small
value and the trim is set to a large value, you may notice very little travel to the throttle.
(Please refer to center trim, P21)
TH
When operating the throttle,
you adjust the operating
movement of the servo.