Main Menu - Ko Propo Esprit-3 Universe Instruction Manual

2 2
This is the menu displayed when the 'ENTER' key is pressed from the initial screen.
Factory default setting CUSTOM1
MODEL
SELECT
SUB TRIM
TH:CURVE
TH:BRAKE
TH:HIPOINT
ST:CURVE
The 'BACK' key is pressed.
Menu Addition
Adding a function to the menu list. You are able to add a function to CUSTOM1 and CUSTOM2.
(You cannot add to the MASTER menu.)
The function names
that can be added to the
menu are listed to the right.
However, once a function is
registered it will no longer be
displayed.
Selecting the Position
Decide the position where the function will be listed in the menu by using the Jog Dial,
(+) or (-) keys and press the 'ENTER' key. The insertion will be fixed and the screen will
return to the selection of the function name.
You can repeat and continually add functions from the same screen. Press
the 'BACK' key to exit this feature. (Or you can return to the initial screen by
pressing and holding at the same time the 'ENTER' and 'BACK' keys.)

Main Menu (1)

to manu addition
If the menu displayed is blinking, it is not registered in the
In the factory default setting, only the function menu registered
ST:BALANCE
ST:TRAVEL
MODEL NAME
In the factory default setting, CUSTOM2 menu is empty.
REVERSE
SET UP
RESPONS
The 'ENTER' is pressed. Jog dial operation
Menu Name Selection
Select the menu name that you wish to add a function to.
Move the cursor to either CUSTOM1 or CUSTOM2 using the
Jog Dial, (+) or (-) keys and press the 'ENTER' key.
Function Name Selection
Using the Jog Dial, (+) or (-) keys, select the function name
that you would like to add and press the 'ENTER' key.
MODEL SELCT
ET:POSITION
SUB:TRIM
ABS
TH:SPEED
TH:PUNCH
TH:CURVE
TH:BRAKE
The initial screen in the main menu becomes the change
menu system screen. MASTER, CUSTOM1 and CUSTOM2
are the displayed names of the menu screen respectively.
Moving the cursor is performed by using the Jog Dial, (+) or (-)
keys.
Pressing the 'BACK' key will return you to the initial
screen.
function menu and cannot be selected.
is the CUSTOM1 menu.
(This cannot be selected until a function is registered.)
(+) and (-) keys are pressed.
TH:HIPOINT AUTO:START
TH:PRESET MODEL.COPY
TH:ACCEL MODEL.NAME
ST:SPEED MEM.RESET
ST:PUNCH ADJUST VR
ST:CURVE CH.SELECT
ST:BALANCE REVERSE
ST:TRAVEL TRIM RATE
Pressing and holding simultaneously the (+) and (-) keys. (Reset)
Selected CUSTOM1
Selected SUB:TRIM
SET UP 3CH POS
UP TIMER BRAKE MIX
DOWN TIMER P.MIXING1
LAP TIMER P.MIXING2
IDLE UP RESPONS
ST:TR PRESET
TILT MIX
CH3:TRAVEL
SUB:TRIM has been
selected on this screen.
It tries to insert
SUB:TRIM after
ET:POSITION on
this screen.
This becomes the order.
(Displayed above)