Steering Travel - Ko Propo Esprit-3 Universe Instruction Manual

Adjust the total range of movement of the steering servo.
Adjusting the total range of movement of the steering servo when the stick is moved all the way to the endpoint.
[How to open the setup screen]
From the initial screen, use the Jog Dial, (+) or (-) keys to enter the function menu.
Using the Jog Dial, (+) or (-) keys you can adjust the settings.
Initial setting value is 100, maximum value is 150 and the minimum value is 0.
Using the Jog Dial, (+) or (-) keys, move the cursor in the menu list to "ST:TRAVEL" and press the 'ENTER'
key.
Press and hold simultaneously the (+) and (-) keys to reset the setting to 100.
To return to the menu list press either the 'BACK' or the 'ENTER' key.
The steering travel is initially set to the ET-3 dial. When the ET-3 dial
is operated, the screen to the right will be displayed automatically.
The number setting displayed while using the ET-3 dial is the ratio of
the steering travel to be used.
(This can be set from 40% ~ 100%)
Setting the steering travel to 0 does not allow movement of the servo.
Using the ET-3 dial will not yield any movement with this setting if set to 0.
To set the endpoints for the left and right movement independently, you will need to use the
steering balance (P48).
Please set the servo accordingly so that there is no excessive strain on the servo.
When there is excessive stress and load on the servo, it will be damaged.
ST TRAVEL (Steering Travel)