Program Mixing - Ko Propo Esprit-3 Universe Instruction Manual

You can apply mixing between arbitrary channels.
This function will allow the mixing between steering, throttle and CH3.
P.MIXING1 and P.MIXING2 functions are an independent mixing control system for each program set.
[How to open the setup screen]
>
From the initial screen use the Jog Dial, (+) or (-) keys to open the Function menu.
Use the Jog Dial, (+) or (-) keys and choose the "P.MIXING" from the menu list and press the 'ENTER'
key.
Press the 'ENTER' key and the adjusting screen will appear.
Please press the 'BACK' key two times to return to the function menu.
[Addition function explanation]
You can offset the center point of mixing for the master channel .
(The point where the direction changes)
Choose (ON or OFF) whether the master channel lets quantity of movement of the trim influence
the mixing of the slave servo in the case of CH1 (steering) or CH2 (throttle).
Choose (ON or OFF) whether to let the output of a slave channel mix a parameter of a function menu
that is set by the master channel.
Related functions are mentioned below.
Steering: SPEED, CURVE, TRAVEL
Throttle: ABS, CURVE, TRAVEL
The movement of slave channel
= (Movement of a master channel) * (the rate set by P.MIXING) + (Control of slave
channel) + (Trim of slave channel)
P.MIXING 1, 2 (Program Mixing 1, 2)
MIX
MODE1:
MODE2:
zST.CH:
SLV.CH:
RATE.L
RATE.R
OFFSET
Only MODE1 is indicated.
When MODE1 is set in mixing mode (MIX), the following menus can be set.
TRIM
FUNC
reflects the settings of the slave channel or not.
OFF/MODE1/MODE2 Mixing selection
Mixing is by stick operation
Mixing from the operation output
Appointing the master channel
which applies the mixing
Appointing the slave channel
which is applied for mixing
Quantity of mixing for theleft steering
Appoint a rate
(-100% reversal turn - 0 - +100% original turn)
Quantity of mixing for the right steering
Appointing the center of master channel
When the Master channel is set for ST
Indication changes with the master channel.
Trim for when the Master channel is ST or TH.
Set whether the trim is reflected
by the slave or not.
Set the function whether the Master channel