Proximity Cards Reader - Pr62 - Connection - Teletek electronics CA60Plus Installation Manual

11.
LED indication:
- green - the card is recogni-
sed or required action is done,
- red - the card is not recog-
nised or required action is
rejected,
- yellow (LED blinks) - ready.
Фиг. 13 PR62 proximity cards reader connection scheme
The PR62 proximity card reader was designed to control security in the systems integrated within the
CA60Plus Control Panel. The excellent card reading distance, the triple color indications, supplemented by
the sound indicator, the integrated output, as well as the fine design, all make the PR62 any attractive supple-
ment to the security system.
The PR62 can be connected to the system bus of the CA60Plus together with the mounted keyboards.
Up to four proximity readers can be included within one security system. Programming the various addresses
onto the readers will provide identification by the TAMPER of each of these. The Table for Address Pro-
gramming is provided in Fig. 13.
The proximity-card enables to arm and disarm the system, as well as to control the electric lock via
integrated output. The internal structure, and the permissible output currents, are provided in Fig. 13.
It is possible that only proximity-card readers be included in a system without having an installed key-
board. In such systems this would hinder current programming of parameters and cards, as well as Log
Review and Technical Trouble indications. Portable LED60, LED61 or LCD62 type keypads can be used to
accomplish such tasks.
Up to 17 cards can be assigned to one security system – one card for each of the 16 users and one card
for the main user.
The main system user programmes the performance of the cards. Arming and/or disarming rights must
be assigned for the respective user code.
The user may not be designated a code combination. In such case the only means to control the
security system would be the proximity-card.
CA60Plus control panel Installation manual
PR62 proximity cards reader
PR62 addresses* JT*
JT* J1 J2
J1
0 0 1
0 1 0
J2
0 1 1
1 0 0
* The JT jumpe r must be set in
the most far unit on the bus.
Two color LED indicator
- PR62 -
LED
Proxi CA62
Lock
Mounting openings
connection
Internal structure of built-in PGM
+12 VDC
1 kΩ
PGMx terminal
Permissable currents:
- from +12 V - up to 10 mA
- towards GND - up to 100 mA
The output activates for 2
seconds after the recognised
card is drown back.
Signal cables
openings
13