Trouble Events; Enrolling / Deleting Of Devices; Enrolling Devices During The Initial Power-Up Of The Control Panel; Enrolling Devices To A Working System Configuration Via Lcd Keyboard - Teletek electronics ECLIPSE 8 Installation Manual

4. TROUBLE EVENTS

The possible system troubles are listed in the table below, together with the respective indication for LED and LCD
keyboards. The sound signalization for a system trouble can be disabled in Menu 2. SETTINGS – 03. TRBL SOUNDS
(ADDRESS 0013 or OPERATION 013). By default, the sound signalization for all system troubles is enabled.
NOTE: The system troubles 7 and 8 are not supported for Eclipse 8 control panel.
LED LCD
 1. AC Loss
 2. Battery Trouble
 3. Blown fuse
4. Tel. line TRBL/

Comm. Fail
 5. Tamper
 6. Sysbus err
 7. Fire line Error
 8. Siren Fault*
* NOTE: It is possible after the initial power-up of the system a trouble message for 8. SOUNDER FAULT to be
displayed on the screen of LCD keyboards (8 zone number lights on the LED display). That indicates some problems
with sounder connected to PGM5. In case the PGM5 is used as a standard output, you have to terminate it with 1K
resistor, or to program it as regular output – disable option 1 at ADDRESS 3051.

5. ENROLLING / DELETING OF DEVICES

5.1. Enrolling Devices during the Initial Power-up of the Control Panel

1. With set RESET jumper on the main PCB power up the Eclipse control panel.
2. Wait the initial initialization of the connected to the system bus keyboards. At the end of the procedure, the
bus LED of all devices including the main PCB is lighting permanently in red. A text message "SW revision XX;
Press ENTER" is displayed on LCD screen, and at LED keyboards is lighting on only the power LED. For LED
8 only buttons are lighting on.
3. Start to press the ENTER button or the address button of other devices – the manufacturer recommends first
to enroll the keyboards in the system, then proxy readers, modules, etc. The system starts an automatic
enrollment procedure of the devices on consecutive addresses starting with address 8020. Remember that the
first enrolled device to the system bus is always the main PCB of the panel. It is strongly recommended the
next enrolled device to be a LCD keyboard for programming.
4. Remove the RESET jumper and wait the system bus LED to stop blinking in green. The system is ready for
further programming and parameter configuration.
IMPORTANT NOTE!
When enrolling devices to ECLIPSE 8 control panel, the first is automatically added to ZONE 7, and
the second to ZONE 8!

5.2. Enrolling Devices to a working system configuration via LCD keyboard

1. Enter engineer code (7777 by default).
2. Press button "9" for direct access to menu "9. DEVICES". Use the buttons with arrows to reach a free
address position for adding a new device. Choose in sequence:
3. Press the ENTER button (for a keyboard), press the button (for module) or place a card (in front of the proxy
readers) of the device connected to the system bus and which you want to enroll to the system configuration.
4. After successful enrollment to the control panel, the screen displays:
Description
The mains power supply is lost.
The accumulator battery is discharged or missing.
Blown out fuse.
Telephone line of the digital communicator is lost & communication with central Monitoring
station fails.
Open tamper in system.
System bus error. It could be short circuit in the line or lost device.
Fire Detector Loss or the fire line is broken.
Problem with connected siren; no siren connected to PGM5.
ХХ. Device [Free] – ENTER – 1. ID – ENTER – [Free] [________]
[Device type] [unique ADDRESS] for the respective device.
Eclipse 8/ 32 Series - Installation Manual
25