Function Test - Toshiba e-STUDIO165 Service Manual

2.2.3

Function test

The function test checks each function of the equipment. To enter the function test mode, follow the
procedure below, or enter the Service mode (*,#,*,*) and select the menu for the function test.
<Key used in operation>
1 3 Power ON
or
ENTER
The following tests can be conducted in the Function test mode.
[A] 01. OPE. PANEL TEST
[B] 02. PRINT TEST
[C] 03. MODEM TEST *1 (Factory test)
[D] 04. SENSOR TEST
[E] 05. SRAM TEST
[F] 06. DRAM TEST
[G] 07. CLOCK IC TEST
[H] 08. SCANNER TEST
[I] 09. CODEC TEST
[J] 10. OUTPUT TEST
[K] 11. PRINTER BOARD TEST *2
[L] 12. USB MEMORY TEST *2
[M] 13. CF TEST *3
*1: When the FAX kit (GD-1220/1221) is not installed, the test is not present.
*2: When the Network Printer kit (GA-1190) is not installed, the test is not present.
*3: When the Scanner Upgrade kit (GA-1200) is not installed, the test is not present.
© 2006 - 2008 TOSHIBA TEC CORPORATION All rights reserved
Select test menu
Fig. 2-4
2 - 83
08/06
<Display messages>
e-STUDIO165/167/205/207/237
ERROR CODE AND SELF-DIAGNOSTIC MODE
2