Toshiba e-STUDIO165 Service Manual page 108

[D] 04. SENSOR TEST
When the machine enters the SENSOR TEST Mode, the status of each sensor is indicated on the dis-
play. The status can be checked by selecting the corresponding bit. (For items to be checked, refer to
the Sensor Test Items table.)
<Key used in operation>
1 3 Power ON
04.SENSOR TEST
ENTER
or
Cancel
• Explanation of status display
When the sensor test is carried out, the
status of each sensor is indicated on the
display with 0 or 1.
Each signal is divided into 8-bit blocks.
The character on the left edge of the dis-
play indicates as follows:
I: Signal input to the IO port
S: Signal from the scanner or R/ADF
P: Signal from the option connected
to the PFC
The display is switched using the or key.
e-STUDIO165/167/205/207/237
ERROR CODE AND SELF-DIAGNOSTIC MODE
Select test menu
Display selection
Fig. 2-7
2 - 86
<Display messages>
I1
S1
Status display example
I 1 I 2
I
I 4 I 5
I 7 I 8
S S 1 S 2
S 3 S 4
P P 1 P 2
Fig. 2-8
© 2006 - 2008 TOSHIBA TEC CORPORATION All rights reserved
Bit
7------0
I9
P2
I 3
I 6
I 9