Toshiba e-STUDIO165 Service Manual page 29

Note: Note:
The density LED blinks while performing adjustment for the items which take time.
Be sure not to turn the power OFF nor perform any other operations while the density LED is
blinking.
Procedure 1
[0][5] Code(MC)
[POWER] [Digital keys]
* Press [#] to enter minus (-).
Procedure 2
[0][5] Code(MC)
[POWER] [Digital keys]
* Press [#] to enter minus (-).
Procedure 3
[0][5] Code(MC)
[POWER] [Digital keys]
Procedure 5
Code(MC)
[0][5]
[POWER] [Digital keys]
Note: Note:
The fuser roller temperature control at the adjustment mode is different from that at the normal
state.
Therefore, the problem of fusing efficiency may be occurred in the test copy at the adjustment
mode. In that case, turn ON the power normally, leave the equipment for approx. 3 minutes after
it has become ready state and then start up the adjustment mode again.
© 2006 - 2008 TOSHIBA TEC CORPORATION All rights reserved
Adjust a value
[ENTER]
[Digital keys] *
Sub code(SC)
[ENTER]
[Digital keys]
Adjust a value
[Digital keys] *
Value
[ENTER]
displayed
Automatic
[START]
adjustment
2 - 7
06/04
Stores
value in RAM
[ENTER]
[POWER]
OFF/ON
Does not store
value in RAM
[CANCEL]
[ENTER]
Stores
value in RAM
[ENTER]
[POWER]
OFF/ON
Does not store
value in RAM
[CANCEL]
[POWER]
[CANCEL]
OFF/ON
Stores
value in RAM
[ENTER]
[POWER]
OFF/ON
Does not store
value in RAM
[CANCEL]
Adjustment
Set manually
[ - ] / [ + ]
e-STUDIO165/167/205/207/237
ERROR CODE AND SELF-DIAGNOSTIC MODE
2