Adjustment Of The Adf/Radf (Mr-2017/3019) - Toshiba e-STUDIO165 Service Manual

3.10 Adjustment of the ADF/RADF (MR-2017/3019)

3.10.1 Adjustment of ADF/RADF Position
Perform this adjustment when the ADF/RADF is not installed in the correct position.
Note: Note:
Check if the image adjustment for the equipment is performed properly before this adjustment of
the ADF/RADF.
[A] Checking
(1) Open the ADF/RADF and install 2 position-
ing pins (the positioning pins are installed to
the back side of the hinge which is on the left
side of the ADF/RADF).
(2) Remove the platen sheet.
© 2006 - 2008 TOSHIBA TEC CORPORATION All rights reserved
Fig. 3-37
Fig. 3-38
3 - 47
e-STUDIO165/167/205/207/237
ADJUSTMENT
3