Toshiba e-STUDIO165 Service Manual page 274

Important:
• The download jig (PWA-DWNLD-350-JIG) has two types having different ROM capacity.
PWA-DWNLD-350-JIG2 (48 MB)
PWA-DWNLD-350-JIG1 (16 MB)
• The download jig (PWA-DWNLD-350-JIG) is the jig in which the Flash ROM is mounted on
the board directly. Therefore, ROM writer adapter (PWA-DL-ADP-350) is required to write the
data to these Flash ROMs. Refer to the following to write the data.
P. 6-7 "6.1.2 Writing the data to the download jig (PWA-DWNLD-350-JIG)"
K-PWA-DLM-320
Important:
Pay attention to the direction of the ROM.
e-STUDIO165/167/205/207/237
FIRMWARE UPDATING
Download jig
Connector Mark for ROM
installation direction
Fig. 6-3 Jig board: K-PWA-DLM-320
ROM capacity
8 MB x 6
8 MB x 2
LED
ROM
© 2006 - 2008 TOSHIBA TEC CORPORATION All rights reserved
6 - 2