Toshiba e-STUDIO165 Service Manual page 288

(4) Connect the USB storage device to the USB connector (host) on the SYS board.
(5) Turn ON the power while [4] button and [9] button are pressed simultaneously.
The items to be updated are highlighted in approx. 20 seconds, and updating starts.
"Install" then "Wait" is displayed next to the item being updated.
Note: Note:
The items to be updated (highlighted items) vary depending on the types of data written on the
USB storage device.
Each item is displayed only when each data file is written on the USB storage device in the fol-
lowing conditions. The item "Controller Data" is displayed when either or both [CON_JIG] and
[SCN_JIG] sub folders are written.
e-STUDIO165/167/205/207/237
FIRMWARE UPDATING
USB connector(host)
Fig. 6-25
Fig. 6-26
6 - 16
06/09
USB storage device
© 2006 - 2008 TOSHIBA TEC CORPORATION All rights reserved