Toshiba e-STUDIO165 Service Manual page 289

Item
SYS_Firm Ware
Func Data
Language Data
Controller Data
If the USB storage device is not recognized properly in approx. 30 seconds, items are not high-
lighted. In this case, turn OFF the power of the equipment, connect the device properly, and then
repeat the procedure from step (5).
(6) When the updating is completed properly, "Complete" is displayed next to all the highlighted
items.
Note: Note:
It takes approx. 9 minutes to complete updating all items (SYS_Firm Ware/Func Data/Language
Data/Controller Data). Update time varies approx. ±30% depending on the rotation speed of the
USB storage device and the status of the Flash ROM in the equipment.
(7) Turn OFF the power and remove the USB storage device.
(8) GA-1190 only: Install the cover plate.
When GA-1200 is installed: connect the dongle to the USB connector (host) and install the cover.
(9) Perform the initialization of the updating data.
• Turn ON the power while [0] button and [8] button are pressed simultaneously.
• Key in "947", and then press the [START] button.
• Press the [START] button.
© 2006 - 2008 TOSHIBA TEC CORPORATION All rights reserved
Model specific folder name
e-STUDIO165/205:
165_205
e-STUDIO167/207/237:
167_237
Fig. 6-27
Fig. 6-28
6 - 17
07/02
Condition
Sub folder name Data file name
cjH_prog.dgb
SYS_JIG
cjH_func.dgb
cjH_lang.dgb
lang.img
rom.img
CON_JIG rom2.img
sysfirm.tz
uiw.img
vxWorks.st_rom.bin
Samba.out
scan.tz
SCN_JIG webdata1.db
webfile.zip
webhelp1.zip
e-STUDIO165/167/205/207/237
FIRMWARE UPDATING
6