Toshiba e-STUDIO165 Service Manual page 155

[F] Right margin
<Procedure>
(1) While pressing [0] and [5] simultaneously, turn the power ON.
(2) Press [4] [FAX]
drawer or 4: PFP lower drawer.)
Print out 2 sheets in A3/LD size.).
(3) Place the paper printed out in step (2) to cover the whole area of the original glass.
(4) Press the [INTERRUPT] button to enter the normal mode.
(5) Make a copy at the mode of A3/LD, 100%, Text/Photo and standard drawer of the equipment.
(6) Press the [INTERRUPT] button to enter the adjustment mode.
(7) Measure the blank area F at the right side of the copied image.
(8) Check if the blank area F is within the range of 2±1.0 mm.
(9) If not, use the following procedure to change values and repeat the steps (4) to (8) above.
(Adjustment Mode)
(Key in a value (acceptable values: 0 to 255))
Press the [ENTER] button (stored in memory).
* The larger the adjustment value is, the wider the blank area at the right side becomes
(approx. 0.04 mm/step).
© 2006 - 2008 TOSHIBA TEC CORPORATION All rights reserved
[PAPER FEED] (Select from 0: bypass, 1: drawer, 2: PFU, 3: PFP upper
[START] (A solid black pattern (whole area) is printed out.
(Key in the code [432])
Feeding direction
Fig. 3-13
3 - 17
06/04
(Adjustment Mode)
[ENTER]
[CANCEL] ("MC" is displayed.)
F
e-STUDIO165/167/205/207/237
3
ADJUSTMENT