Toshiba e-STUDIO165 Service Manual page 34

Classi-
Code
fication
365 ADF/ ADF/RADF
RADF leading edge
position
adjustment
366 RADF
401 Laser Fine adjustment of polygo-
nal motor rotation speed
(adjustment of primary
405
scanning direction repro-
duction ratio)
410 Laser Adjustment of primary
scanning laser writing start
position.
411
421 Drive Adjustment of secondary
scanning direction repro-
duction ratio
422
(fine adjustment of main
motor speed)
424 Drive Fine adjustment of exit
motor speed
425
430 Image Top margin adjustment
(blank area at the leading
edge of the paper)
431 Image Left margin adjustment
(blank area at the left of the
paper along the paper
feeding direction)
432 Image Right margin adjustment
(blank area at the right of
the paper along the paper
feeding direction)
433 Image Bottom margin adjustment
(blank area at the trailing
edge of the paper)
e-STUDIO165/167/205/207/237
ERROR CODE AND SELF-DIAGNOSTIC MODE
Adjustment mode (05)
Func-
Items
tion
for single ALL
sided orig-
inal
for double ALL
sided orig-
inal
PRT
PPC
PPC
PRT
PPC/
PRT
FAX
PPC/
PRT
FAX
PPC
PPC
PPC
PPC
2 - 12
Default
<Accept-
RAM
able
value>
50 SYS When the value
<0-100> increases by "1", the
copied image of original
fed from the ADF/RADF
50 SYS
shifts toward the trailing
<0-100>
edge of paper by approx.
0.2 mm.
During this adjustment,
the density LED blinks.
134 M When the value
<0-255> increases by "1", the
reproduction ratio of pri-
131 M
mary scanning direction
<0-255>
increases by approx.
0.07%. (approx. 0.1 mm/
step)
88 M When the value
<0-255> increases by "1", the writ-
ing start position shifts to
88 M
the front side by approx.
<0-255>
0.0423 mm.
When "1" is set at 08-
203, the adjustment
value set at 05-411 will
also be reflected to 05-
410.
128 M When the value
<0-255> increases by "1", the
reproduction ratio of sec-
128 M
ondary scanning direc-
<0-255>
tion increases by approx.
0.04%.
128 M When the value
<0-255> increases by "1", the
rotation becomes faster
128 M
by approx. 0.05%.
<0-255>
9 M When the value
<0-255> increases by "1", the
blank area becomes
wider by approx.
0 M
0.0423 mm.
<0-255>
110 M
<0-255>
153 M
<0-255>
© 2006 - 2008 TOSHIBA TEC CORPORATION All rights reserved
Proce-
Contents
dure
1
1
1
1
1
1
1
1
1
1
1
1
1
1