Firmware Updating With Software Update Tool - Toshiba e-STUDIO165 Service Manual

6.4

Firmware Updating with Software Update Tool

6.4.1 General Description
The software update tool is used for upgrading the version of the system ROM for the equipment. You
can download the system ROM data from a PC to equipment by installing this tool and connecting a PC
with the equipment using a USB cable.
6.4.2 System Requirements
Tools introduced in this manual shall be operated under the following systems:
• OS : Windows 2000 SP4, Windows XP SP1, Windows XP SP2
• USB version : USB Ver.2.0 (Recommended)
• USB Cable : USB2.0 Hi-Speed certified cable (USB cable supporting the USB2.0 Hi-Speed mode
(480 Mbps of transfer speed) certified by the USB Implementers Forum.)
6.4.3 Preparation and Precaution
(1) Confirm that there is a software updating tool USB driver (created by decompressing
"eST163_PCDL_Inst_Rev210.zip") on your PC.
(2) Only installation by hardware wizard can recognize e-STUDIO165/167/205/207/237.
(3) If the TOSHIBA Viewer USB driver is already installed, the software update tool USB driver can-
not be. Delete the corresponding COM port on the Device Manager window and then start the
installation of the software update tool USB driver.
6.4.4 Update Procedure
(1) Turn OFF the power of the equipment, and connect the equipment and PC with a USB cable.
Note: Note:
Do not connect the USB of GA-1190/GA-1200 if GA-1190/GA-1200 is installed.
(2) Turn the power ON while pressing [2] and [9] buttons simultaneously.
Notes:
1. The following screen appears on the control panel when the equipment goes into the update
mode.
2. Refer to Note in step (11) for the screen displayed during the update.
(3) Double-click the icon "FirmwareDownload.exe" to start up the Software update tool.
© 2006 - 2008 TOSHIBA TEC CORPORATION All rights reserved
Fig. 6-29
6 - 19
07/06
e-STUDIO165/167/205/207/237
FIRMWARE UPDATING
6