Toshiba e-STUDIO165 Service Manual page 101

Classifi-
Code
cation
1994 Network Enable server's IP address
acquired by DHCP
1996 Network Enable server's IP address
acquired by DHCP
<<PM management setting code>>
• The following items are displayed or set by using sub-codes at PM management setting in the table
below.
<Sub-codes>
0: Present number of output pages
- Means the present number of output pages.
1: Recommended number of output pages for replacement
- Means the recommended number of output pages for replacement.
3: Present driving counts
- Means the present drive counts (1 count = 2 seconds).
4: Recommended driving counts to be replaced
- Means the recommended drive counts for replacement (1 count = 2 seconds).
6: Present output pages for control
- Means the present number of output pages for controlling.
7: Present driving counts for control
- Means the present drive counts for controlling (1 count = 2 seconds).
Notes:
• Sub-code 3 is equivalent to sub-code 7.
When the value of sub-code 3 is changed, the value of sub-code 7 is also updated and vice
versa.
• Sub-code 0 is equivalent to sub-code 6.
When the value of sub-code 0 is changed, the value of sub-code 6 is also updated and vice
versa.
• When "0" is set at one of sub-codes 0, 3, 6 and 7, the rest of them are automatically updated
to "0".
© 2006 - 2008 TOSHIBA TEC CORPORATION All rights reserved
Setting mode (08)
Default
Func- <Accept-
Items
tion
value>
ALL
ALL
2 - 79
07/02
RAM Contents
able
2 CTL the Pop3Server Option
<1-2> (70) Post Office Server
Addresses
1: Enabled
2: Disabled
* This value is used
only when DHCP is
enabled.
2 CTL SNTP Server Option
<1-2> (42) NTP Server
Addresses
1: Enabled
2: Disabled
* This value is used
only when DHCP is
enabled.
e-STUDIO165/167/205/207/237
ERROR CODE AND SELF-DIAGNOSTIC MODE
Proce-
dure
1
2
1