Toshiba e-STUDIO165 Service Manual page 220

[E03] Paper remaining inside the equipment at power-ON
Open the cover of the unit/area whose picture is blinking on the control panel. Is there any
paper on the transport path? (Refer to the following table.)
YES
NO
Is the sensor in the jamming area working? (Perform the input check in the test mode: refer
to the following table.)
l NO
l
l
l
l
l
l
l
YES
Replace the MAIN board.
Relation between the jamming area and the corresponding sensors and covers
(If a jam is occurring in the PFU, check the PFU board.)
Jamming area
Registration area Transfer cover
Exit area Transfer cover
PFU PFU side cover
e-STUDIO165/167/205/207/237
TROUBLESHOOTING
Remove the paper.
1) Check if the connector of the sensor is disconnected.
2) Check if any of the connectors on the MAIN board is disconnected.
3) Check if the connector pins are disconnected and the harnesses are
open circuited.
4) Check if the conductor pattern on the MAIN board is short circuited or
open circuited.
5) Replace the sensor.
6) Replace the MAIN board.
Cover
Registration sensor
Exit sensor
PFU feed sensor
5 - 2
Sensor Test mode / Input check
13-[04. SENSOR TEST]
13-[04. SENSOR TEST]
13-[04. SENSOR TEST]
© 2006 - 2008 TOSHIBA TEC CORPORATION All rights reserved