Toshiba e-STUDIO165 Service Manual page 33

Classi-
Code
fication
341 Scanner Solid line erasing in image
shift (right margin)
350 Scanner Shading posi-
tion adjust-
ment
351
354 ADF/ Adjustment of
RADF ADF/RADF
paper align-
ment
355 RADF
357 ADF/ Fine adjustment of ADF/
RADF RADF transport speed
358 ADF/ ADF/RADF sideways devi-
RADF ation adjustment
359 Scanner Carriage position adjust-
ment during scanning from
ADF/RADF
© 2006 - 2008 TOSHIBA TEC CORPORATION All rights reserved
Adjustment mode (05)
Default
Func- <Accept-
Items
tion
value>
PPC
<0-60>
Original ALL
glass
RADF ALL
for single ALL
sided orig- <0-20>
inal
for double ALL
sided orig- <0-20>
inal
ALL
<0-100>
ALL
<0-255>
ALL
<0-255>
2 - 11
08/06
RAM Contents
able
0 SYS If copies are made using
the ADF with the image
shift (right margin) func-
tion enabled, black
streak lines may appear
on the trailing edge of
the copies.
To erase this line, use
this code to adjust the
scanning range.
When the value
increases by "1", the
image scanning range
decreases by 0.1 mm.
128 SYS 0.064 mm/step
<118- During this adjustment,
138> the density LED blinks.
128 SYS
<118-
138>
10 SYS When the value
increases by "1", the
aligning amount
increases by approx.
10 SYS
0.4 mm.
50 SYS When the value
increases by "1", the
reproduction ratio of the
secondary scanning
direction when using the
ADF/RADF increases by
approx. 0.1%.
During this adjustment,
the density LED blinks.
128 SYS When the value
increases by "1", the
image of original fed
from the ADF/RADF
shifts toward the rear
side of paper by approx.
0.169 mm.
During this adjustment,
the density LED blinks.
128 SYS When the value
increases by "1", the car-
riage position when
using the ADF/RADF
shifts by approx. 0.1 mm
toward the original feed-
ing side.
During this adjustment,
the density LED blinks.
e-STUDIO165/167/205/207/237
ERROR CODE AND SELF-DIAGNOSTIC MODE
Proce-
dure
1
2
1
1
1
1
1
1
1