Rep 1.5 Control Panel Cover - Xerox ColorQube 8570 Service Manual

REP 1.5 Control Panel Cover

Parts List on PL 1.1 Item 5
Removal
Use care not to damage the Control Panel Wiring Harness while removing or replacing the
Control Panel Cover.
Do not disconnect the ZIF cable and remove the Control Panel unless necessary, as the Con-
trol Panel connector is fragile and can be easily damaged, even when correctly following the
replacement procedures.
1. Open the Exit Cover.
2. Open the Front Door.
Figure 1 Opening the Exit Cover and Front Door
Repairs and Adjustments
REP 1.5
CAUTION
CAUTION
3. Using either your fingers or a small flathead screwdriver, loosen the Control Panel Cover
on the left side, and then slide the Cover forward while lifting up to remove it from the
printer.
Figure 2 Removing the Control Panel Cover
October 2012
4-6
Revised, 3rd Revision - Xerox Internal Use Only
ColorQube 8570/8870 Service Manual