Xerox ColorQube 8570 Service Manual page 265

Replacement
When replacing the Head Tilt Solenoid screw, torque to no more than 12 in.-lbs. Overtightening
this fastener can result in irreversible damage to the chassis.
To ensure proper operation of the Printhead following reassembly, perform these steps in the
order given.
1. Insert the plastic end of Head Tilt Solenoid into the frame, swing to the right and replace
the screw.
2. With the Printhead centered on the Drum, use a screwdriver to turn the lower screw of the
Process Drive clockwise until you hear the Head Tilt Solenoid snap into place (see
4 for Head Tilt Latch position).
Figure 3 Engaging the Head Tilt Solenoid
Xerox Internal Use Only - Revised, 3rd Revision
ColorQube 8570/8870 Service Manual
CAUTION
CAUTION
Figure
October 2012
4-71
Figure 4 Head Tilt Latch Position
Repairs and Adjustments
REP 4.4