Xerox ColorQube 8570 Service Manual page 285

Replacement
Be sure to connect P/J703 on the Main Controller Board and
Board to the Power Control Board.
Figure 7 Connector and Screw Locations
Be sure to seat the two side corners of the Panel on top of the Power Control Board, and the
middle section of the Panel on the outside of the Cage.
Figure 8 Installing the Side Panel
Xerox Internal Use Only - Revised, 3rd Revision
ColorQube 8570/8870 Service Manual
Power Control Board
Removal
JDC1 on the Power Supply
Be sure to disconnect AC power prior to disassemble the Electronics Module.
1. Turn the Board Assembly Module over with the bottom of the Power Control Board facing
upward.
2. Remove 3 screws (metal, T-9) that secure the Power Control Board and remove the
Power Control Board support rail.
3. Gently wiggle the Power Control Board to disconnect the
from the Power Supply Board.
October 2012
4-91
WARNING
Figure 9 Removing the Screws and Support Rail
P/J403 and P/J601 connectors
Repairs and Adjustments
REP 5.6