Rep 4.10 Head Maintenance Clutch; Rep 4.11 X-Axis Motor - Xerox ColorQube 8570 Service Manual

REP 4.10 Head Maintenance Clutch

Parts List on PL 4.1 Item 10
Removal
1. Remove the Control Panel Cover (REP
2. Remove the Right Side Cover (REP
3. Disconnect the Head Maintenance Clutch wiring harness connector
ing harness.
4. Remove the KL-Clip.
5. Remove the Head Maintenance Clutch.
Figure 1 Removing the Head Maintenance Clutch
Replacement
Perform the Homing the Printhead Forward to Print Position procedure
Drive Alignment procedure (ADJ 1.3) before restoring printer power.
Repairs and Adjustments
REP 4.10, REP 4.11
1.5).
1.11).
P/J119
(ADJ 1.2) and Process

REP 4.11 X-Axis Motor

Parts List on PL 4.1 Item 11
Removal
1. Remove the Control Panel Cover
2. Remove the Right Side Cover
from the wir- 3. Disconnect the X-Axis Motor wiring harness connector
4. Remove 4 screws (plastic, T-20) that secure the motor to the frame.
5. Remove the X-Axis Motor.
Replacement
Engage the fork extending from the cone-nut of the Motor Assembly with the chassis rib as
shown in Figure 1. Also, slip the mounting plate behind the ground strap and replace the cable
retainer on the lower right screw. Perform the Homing the Printhead Forward to Print Position
procedure (ADJ 1.2) and Process Drive Alignment procedure
power. Note, do not over tighten the screws as the holes in the chassis strip out easily.
October 2012
4-78
(REP 1.5).
(REP 1.11).
P/J123
Figure 1 Removing the X-Axis Motor
(ADJ 1.3) before restoring printer
Revised, 3rd Revision - Xerox Internal Use Only
ColorQube 8570/8870 Service Manual
from the Motor.