Xerox ColorQube 8570 Service Manual page 225

23. Disconnect the Drum Heater Load Dump wiring harness connector P/J120, Drum Heater
wiring harness connector P/J114, and Encoder wiring harness connector
the Right Side Harness.
24. Release the wiring harnesses from the restraint.
Figure 3 Disconnecting the Wiring Harness Connectors
Xerox Internal Use Only - Revised, 3rd Revision
ColorQube 8570/8870 Service Manual
25. Remove 3 screws (metal, 5.5 mm hex-head), 2 washers, and the Ground Plate from the
P/J122 from right side of the Drum Assembly as shown in
26. Remove 3 screws (metal, T-20) and 3 washers from the left side of the Drum Assembly.
27. Lift the Drum Assembly straight out of the chassis using the metal grips provided.
NOTE: Do not rest the Drum Assembly on the pulley. Allow the pulley to overhang the surface
and rest the assembly on its feet.
28. Place the Drum Assembly on its feet on a flat surface with the wheel overhanging the sur-
face area as shown in
October 2012
4-31
Figure 4.
Figure 4 Removing the Drum Assembly
Figure 5. Do not rest the Drum Assembly on the pulley.
Figure 5 Drum Assembly Placement
Repairs and Adjustments
REP 2.4