Xerox ColorQube 8570 Service Manual page 270

12. Remove 1 screw (metal, T-20) that secures the X-Axis Spring Retainer to the chassis.
Figure 2 Removing the X-Axis Spring Retainer
13. Unlock the Wiper Blade and raise the Wiper Blade to the top of its travel.
Figure 3 Raising the Wiper Blade
Repairs and Adjustments
REP 4.8
14. Remove the Waste Tray Cover without disconnecting the Waste Tray Sensor harness.
a. Lift the center of the cover to release the right side hook.
b. Move the cover towards the back to release the 2 tabs from the chassis.
c. Pull the cover right to release the left hook and position the cover out of the way.
Figure 4 Removing the Waste Tray Cover
15. Reach into the Waste Tray cavity and pull the gear and shaft from the chassis.
Figure 5 Removing the Head Tilt Gear
October 2012
4-76
Revised, 3rd Revision - Xerox Internal Use Only
ColorQube 8570/8870 Service Manual