Xerox ColorQube 8570 Service Manual page 289

Replacement
Route the cables through the slots provided. Position the T-shaped strain relief near the Wave
Amplifier following installation.
Be sure to align the pins in the rear of the Wave Amp Board.
Lay the Wave Amp on top of the flat surface on the rear of the printer to connect the wiring har-
ness connector as shown in Figure 5.
Figure 5 Positioning the Wave Amp
Xerox Internal Use Only - Revised, 3rd Revision
ColorQube 8570/8870 Service Manual
Be sure to secure the wiring harness connector
Figure 6 Securing the ZIF Connector
Perform the Homing the Printhead Forward to Print Position procedure
Drive Alignment procedure (ADJ
October 2012
4-95
P/J640 and lock the ribbon cable in place.
(ADJ
1.3) before restoring the printer power.
Repairs and Adjustments
1.2) and Process
REP 5.9