REP 4.4 Head Tilt Solenoid
Parts List on
PL 4.1 Item 4
Removal
1.
Remove the Control Panel Cover
(REP
2.
Remove the Left Side Cover
(REP
3.
Remove the Right Side Cover
(REP
4.
Lower the Wiper Blade to its lowest position by rotating the Wiper Drive Gears.
Figure 1 Lowering the Wiper Blade
Repairs and Adjustments
REP 4.4
1.5).
1.10).
1.11).
5.
Disconnect the Head Tilt Solenoid wiring harness connector
Harness.
6.
Remove 1 screw (plastic, T-20) that secures the solenoid actuator to the frame. and
remove it from the frame.
7.
Release the hook to release the Solenoid from the frame.
Figure 2 Removing the Head Tilt Solenoid
October 2012
4-70
P/J107
from the Left Side
Revised, 3rd Revision - Xerox Internal Use Only
ColorQube 8570/8870 Service Manual