Xerox ColorQube 8570 Service Manual page 221

Do not push hard on the cable or otherwise bend the end of the cable.
NOTE: Be sure to use the Unlock/Lock Tool to secure the ZIF connector as shown in
(see details in Unlocking/ Locking the ZIF Connector
4. Gently place the end of the Wave Amp Drive cable
tor.
5. While maintaining slight downward pressure on the cable to keep the end in the connector
gently reach in with the tool to squarely push the lock closed.
Figure 21 Securing the ZIF Connector
6. Seat and lock the Ribbon Cable P/J180.
7. Lower the Printhead Assembly into its mounts. The Printhead should tilt forward in the
print position.
8. Route the Purge Pump Hose through the frame and connect it to the Purge Pump.
Xerox Internal Use Only - Revised, 3rd Revision
ColorQube 8570/8870 Service Manual
CAUTION
procedure).
P/J240 squarely into the ZIF connec-
9. Install the Roll Block on the left end of the Printhead Shaft. Orient the Roll Black as shown
on the label attached to the frame (see
orientation.
Figure 21
October 2012
4-27
Figure 22). The check mark indicates the correct
Figure 22 Roll Block Orientation
Repairs and Adjustments
REP 2.3