NOTE: Observe the orientation of the RAM device before removing it from the Board.
Be careful when releasing the clips to prevent damaging them.
2.
Release the clips that secure the RAM module and remove the RAM from the Main Con-
troller Board.
Figure 2 Removing the RAM
Repairs and Adjustments
REP 5.3
CAUTION
Replacement
NOTE: Memory should be installed in the primary socket before installing in the secondary
socket. The primary memory socket resides on the left side (away from the processor).
Upgrade memory should be added to the secondary memory slot residing on the right side
(close to the processor).
Be sure to secure the RAM in place.
October 2012
4-86
Figure 3 Installing the RAM
Revised, 3rd Revision - Xerox Internal Use Only
ColorQube 8570/8870 Service Manual