Front Caliper - Honda Prelude 1993 Service Manual

Front Caliper
Disassembly
a N6vor uso an air hose or dry brush to clean brake
ass€mbli9s.
a Use an OSHA-approved vacuum clgan€r to avoid
broathing brake dust.
CAUTION:
a Do not spill brak€ fluid on the ca1; it may d8mag€ the
paint; il brake fluid do€s contact the paint, wash it
ofl immediatoly with wat6r.
a To plevent spills, cover the hose ioints with rags or
shop towels.
a Clean all parts in brak6 tluid and air dry; blow out all
passages with comprossed air.
1. Remove the banjo bolt and disconnect the brake
hose from the calioer.
2. Remove the caliper bolts, then remove the caliper.
SEALING
WASHERS
Replace.
CALIPER BOLT
1 9 - 9
4 .
lf necessary, apply compressed air to the caliper
fluid inlet to get the piston out. Place a shop rag or
wooden block as shown to cushion the oiston
when it is exoelled.
Use low pressure air in short spurts.
Remove the piston from the caliDer.
a Do not placo your fingsrs in front of th€ piston.
a Do not use high air pressuls; use an OSHA-
approvsd 30 PSI nozzle.
Remove the piston boot and piston seat.
CAUTION: Take care not to damago the cylindel
bore,