Honda Prelude 1993 Service Manual page 1241

Hide thumbs Also See for Prelude 1993:

Table of Contents

Shift Lock Solenoid Test/Replacement

1. Remove the console, then disconnect the 3-P con-

nector of the shift lock solenoid from the main wire

n a r n e s s .

NOTE: Do not connect power to the B l-) terminal

{reverse polarity} or you will damage the diode in-

side the solenoid.

Connect batterv oower to the A terminal and

ground to the B terminal momentarily. Check the

solenoid to see if it works. lf it does not work,

a When the shift lock solenoid is ON, check that

there is a cleafance ol 2.9 ! O.5 mm {0.1 14 t

0.020 in) between the top corner of the shift

\ack\e\e\ andthe \ock p\n qroo\e \see c\earance

check on this paqe).

a When the shift lock solenoid is OFF, make sure

that the lock pin is blocked by the shitt lock

a lf it is not, adjust the position of the shift lock

Rsplacement:

1. Remove the solenoid pin.

Remove the self-locking nuts and shift lock

lnstall the new shift lock solenoid in the reverse

order of removal and adjust its position.

a when the shift lock solenoid is ON. check that

t h e r e i s a c l e a r a n c e o J 2 . 9 t O . 5 m m ( O . 1 1 4 a

0.O2O in) between the top corner of the shift

lock lever and the lock pin groove, and tighten

the self-locking nuts.

NOTE: Use brand-new selflocking nuts.

2.9 r 0.5 mm

(0.'114 r O.O2O Inl

when the shift lock solenoid is OFF, make sure

that the lock pin is blocked by the shift lock

Troubleshooting