Windshield - Honda Prelude 1993 Service Manual

Hide thumbs Also See for Prelude 1993:
Table of Contents

Advertisement

Windshield
Removal
CAUTION:
. Woar glov63 to remove and Instal the windlhiald.
. Use aeat covols to avoid damaging any surfaces.
1. To remove the windshield, first remove the:
r Rearview mirror (see psge 2G13)
. Sunvlsors (see page 2G36)
. Front pillartrim (see page 2G37)
. Front wipers snd air scoop {see section 23)
2.
Detach the clips from the retainers, then remove the
side section of the windshield molding as shown.
NOTE:
lf necessary, replsce 8ny dsmaged clips.
3,
Peel off the upper section ol the windshieH rnolding.
NOTE:
Wh6n the upper section of the windshield molding
removal is difficutt, cut oll the windshield molding.
WINDSHIELD
MOLDING
l\..n'
@Y
CORNER CLIP
WINDSHIELD
MOLDING
\
\)v/
#
RETAINER
20-15
4.
Pulldown the front ot the front headlin€r (see psgG
2G36).
CAUTION:
Take caro not to bond the h6adln6r oxcosrivev.
5.
Remove the other retainers and Jast€ners from the
body.
6, Apply p.ot€ctiva tape along the edgo of the dashboard
and body as shown.
Using an awl, mske a hole through the rubber dam and
sdhesive from inside the car. Push the oiano wire
throught the hole and wrap each end around I piece of
wood.
PROTECTIVE
TAPE
7.
With € helpe. on the outside, pull the piano wire back
and forth in a sawing motion and careJully cut through
the adhesive around the entire windshield, then
carefully remove the windshield.
CAUTION:
HoH tho plano wlre as closo to tho wlndshioH as
possiblo to pr6vent damago to tho body 8nd
dashboard.
PI,ANO WIRE
WINOSHIELD
GLASS BRACKET
Z ;Erl
/ h (
/ / '
NOTE:
It necessary, remove the screw, then replace the ghss
bracket.
PROTECTIVE TAPE

Advertisement

Table of Contents
loading

Table of Contents