Honda Prelude 1993 Service Manual page 757

4 .
5 .
6 .
Coat the surface of the 4-way valve with power
steering fluid, and install into the valve body.
Coat the surface o{ the plungers with power steer-
ing tluid, and install the plungers, return springs
and rollers on the valve body.
SPRINGS
Coat the port seal with power steering fluid, and in-
stall it the groove of the port housing. Then install
the valve body and port housing.
mm
I
r 0
1 1
PLUNGERS
E
PORT HOUSING
rol
1 7 - 1 1 1
VALVE BODY
PRESSURE
7. Coat the pressure control valve and gain conttol
valve with power steering fluid, and installthem in-
to the valve body,
8. Install the valve springs.
VALVE SPRINGS
VALVE
9. Coat the cap seal with power steering fluid, and in-
stall it in the groove ot the valve body cap.
1O. Install the valve body cap on the valve body with
6 mm flange bolts.
CAUTION: Maka sure the mating surface ot th6
valve body and cap are flush at the uppor sid6.
VALVE BODY CAP
{cont 6
CONTROL
E
VALVE BODY
6 mm FLAIIGE BOLT
9 N.m (0.9 kg-m, 7 lb-ft)