Honda Prelude 1993 Service Manual page 779

NOTE: Install the boot band with the rack in the
straight ahead position (i.e. right and left tie-rods are
equal in length).
84. lnstall the boot band so that the locking tabs of the
band (stake pointsl are in the range shown below.
(Locking tabs should tace up and slightly forward.)
85. Install new boot bands on the boot and bend both
sets of locking tabs.
86. Lightly tap on the doubled-over ponions to reduce
their height.
CAUTION:
a Stako the band locking tabs firmly.
a When staking. be car€tul not to damag€ the
boot.
AIR HOSE CLIP
(Viewed lrom the right side)
Clamp
AIR HOSE
CLIP
atR HosE
lnstall the air hose cliD as shown.
lnstallthe band cushion and air hoss band; Dosition
the band as shown then tighten it. Install the air
hose,
After assembling, slide the rack right and left to be
cenain that the boots are not deformed or twisted.
NOTE: After installation, perform the electrical
check on the 4wS system (see page 17-146).
AIR HOSE BAf{O
(Viewed lrom the right side)
6 m m
AIN HOSE BAND
8 7 .
8 8 .
8 9 .
NOTE: Connect with the
protector side toward
th6 gearbox,
TUBE
JOINT
Front +
4 5 i 5 o
LOCKING TA&S
The locking tabs (stake
points) should be in this
range.
Band winding
direction.
OFFSET SHAFT
CENTER LINE
LEFT BOOT BAND
(Viewed from the lelt side)
1 0 a 5 0
RIGHT BOOT BAND
(Viewed from the right side)
17-133