Honda Prelude 1993 Service Manual page 640

Hide thumbs Also See for Prelude 1993:

Table of Contents

lnstallation

Installthe outboard joint in the knuckle, then loose-

ly install the spindle nut.

Apply 1 .O- 1 .5 g (O.O4-O.O5 oz) of specified

grease to the whole spline surface of the in-

termediate shatt,

NOTE: Atter applying grease, remove the grease

from the spline grooves at intervals of 2-3 splines

and Jrom the set ring groove so air can bleed from

the inboard joint.

Install the new set ring onto the driveshaft or in-

termediate shaft groove.

CAUTION: Always use a new set dng whon6va?

th6 drivoshatt is being installod.

Install the inboard end of the driveshaft into the dit-

ferential or intermediate shaft.

NOTE: Atter applying grease, rcmove

grease from the spline grooves at int(

ot 2-3 splines and trom the set ring g

INTERMEDIATE SHAFT

INBOARD JOINT

Make sure the right driveshaft locks in the dit{eren-

tial side gesr groove, and the CV ioint sub-axle

bottoms in the ditterential.

Insert the le{t driveshaft CV joint sub-axle anto

the intermediate shaft until the intermediate shaft

set ring locks in the groove in the lelt driveshaft.

SET RING GROOVE

LEFT DRIVESHAFT

( c o n t d I

Troubleshooting