Honda Prelude 1993 Service Manual page 950

6, Inst8ll the glEss brackets, retainers and fasteners to
the body as shown,
NOTE:
Do not tighten the glass bracket mounting sclews.
UPPER FASTE ER
CENITER
FASTENER {1}
326.5 mm
1 1 2 8 5 I n l
RETAII{ER {8I
GLASS BBACKET (2}
FASTENER
l \
;-\
lfiftm?
I
L\_r=
\ _ . :
7.
Set the windshield upright on the glass brackets, then
center it in the windshieH opening. Mske slignment
marks across the windshield and body with I grease
D€ncil at the four points shown.
ALIGNMENT MARKS
WII{DSHIELD
WINDSHIELD
GLASS BRACKETS
NOTE:
Adjust th6 glsss brack€ts until
th6ro is 6 sap ol 1
'l mm (0.4 in)
botwesn ths uppgr sdge ot the
windshieh snd the l€ading edgs of
t h € r o o l , t h 6 n t i g h t € n t h e
mounting sct6ws.
11 mm 10.43Inl
With 8 sponge, apply a light coat of glass primer
around the edge of the windshield as shown, then
lightly wipe it off with gauze or cheesecloth.
NOTE:
. Do not apply body primer to the windshield, and do
not get body and glass primer sponges mixed up.
. Never touch the primed surfaces with your hands. lf
vou do, the adhesive may not bond to the
windshield properly, causing a leak atter the
windshield is installed.
. Keep wster, dust. and abrasive materisls away from
the primed surface.
/////f
: Agply slast$lmd h6ro.
CENTER
FASTEI{ER
RUBEER DAM
WINDSHIELD
UPPER FASTENER
WINDSHIELD
9.
With a sponge, apply a light coat of body p.imer to tho
origin8l adhesive remaining around the windshield
opening flsnge. Th€ windshield should be installed 10
minutes after you apply the body primer,
NOTE:
. Do not appv glass primer to the body. and be
carefulnot to mix up gl€ss and body primer sponges.
. Never touch the primed surfaces wlth your hands.
. Mask off the dashboard before painting the flange.
'//Z
I Apd,t bod,t Nlmor horo.
(conl d\
I mm 10.35 in)
30 mm ('1.18 inl
20-17