Honda Prelude 1993 Service Manual page 577

Secondary Shaft
Inspection
. Cbaranca Maasurement
NOTE:
Lubricst€ all parts with ATF during sssemblv.
1. R€move the secondsry shaft bearing trom the
transmission housing (see psgo 1+129).
2. Assomble the s6condsry shEft sssembly without
O-rings. Instsll th6 idler gear using a press, then to.qu€
the 36cond8ry thaft locknut to
30 N.m (3.0 ksFm , 22 lb-tt)
NOTE:
Do not instsllthe O-rings during inspection.
3. Attach the disl indicator to 2nd gear as shown.
LOCKITUT
DAL INOICATOR
2ND GEAR
4 .
Messure 2nd gears axial clearance while moving 2nd
gear,
STANDARD: 0.07-0.15 mm (0.003-O.0O6 in)
NOTE:
Take measurements in at loast thlee plscos, and use
the average as the actusl clearance.
5.
It the clearance is out of tolerance, remove the splinsd
washer and measure the thickness.
SPLINED WASHER
No. Pari l{umbol
fhbknols
90406 - PX4- 700
4.05 mm 1O.159 in)
90407-PX4-7@
4.10 mm (0.161 in)
90408- PX4- 700
4.15 mm (0.163 in)
4
90rto9- PX4- 700
4.20 mm (0.165 in)
5 90410-PX4-7@
4.25 mm (0.167 in)
o
9 0 4 1 1 - P X 4 - 7 m
4.30 mm {0.169 in)
90412-?X4-70o
4.35 mm 10.171 in)
8
90413-PX4-700
4.2!O mm {0.173 inl
I
90414-PX4-700
4.45 mm {0.175 in)
6.
After r8plscing the splined washsr, make sur€ that the
clearance is within tolgrance.
1 4 - 1 1 6