Honda Prelude 1993 Service Manual page 756

Steering Gearbox
Valve Body Unit
Assembly
lllustrat€d lnd€x
1, Throughly clean the disassembled parts shown below.
2. Coat the plungers, pressure control valve, gain control valve and 4-way valve surfaces with power steering fluid.
3,
Beassemble the pans in the reverse order of disassembly.
CAUTION:
a Replaco the O-rings and ssals with n€w onos,
a Do not dip tho O-dngs and saals in solvent.
a Apply tb€ power ste€dng fluid in the e€al groovos to keep tho leals in pl8cs,
. -6f : STEERING GREASE (Pa.t Numb€r O8733-BO?OE|
45.5 x 2 mm
O.RING
Replace.
1l mm O-RING
PORT HOUSING
DOWEL PII{S
PRESSURE
cof{TRoL
VALVE
uo.u."r*nol trN
S*"MS^"..'.
. \ / l i l
- -
\
+ w r v v t v e
' " / ) H
^ d \
6 mm FLANGE BOLT
I N.m lO.9 kg-m, 7 lb-ft)
PLUNGERS
VALVE EODY
SPRINGS
ROLLER
qq
\ oo,n "onrro.
1 \
vALvE
\
sENsoR oRtFtcE
3.4 m]n O-RING
R6place.
NOTE: lf the valve body is damaged, replace the valve body unit (valve body. pressure control valve, gain control
valve, 4-way valve) as an assembly.
1 7-1 1 0