Honda Prelude 1993 Service Manual page 600

Install the transmission mount. Tighten the bott then
tighten the nuts to specified torque, and retighten the
boh to specified torque.
NUTS
1O x 1.25 mm
39 N'm (3.9 kem,28 b-ft)
Remove the transmission jack.
Attach the torque converter to the drive plats with
eight bolts, snd torque to 12 N.m (1.2 kg-m, 9lb-ft).
Rotate the crankshsJt 8s necessary to tighten th€
botts to
'll2
of the specified torque, then linaltorque,
in I crisscross Dattern.
After tightening the last bolt, check thst the
crankshaft rotstes freslv.
6 x 1 . O m m
75 N'm (7.5 kgtsm . 54 h-ft)
8.
o
1 2 r 1 , 2 5 m m
65 N.m {6.5 kgim , 47 h-ft)
SHIFT CABEL
10. lnstafi the control lsvsr with the shift cable on the
control shaft,
CAUTION:
Tak6 cara not to bond tho shlft cEHo.
1 1 . lnstall the lock boh with a new lock washer, then bend
ths lock tab.
12. Instsll the toroue converter cover and shift cable
covar.
cot{TRoL
LEVER
LOCK
WASHER
R6plsc€.
LOCI( BOLT
6 x 1 . O m m
14 N'm (1.4 ks-m ,
10 b-ft)
TOROUE
COI{VERTER
COVER
CONTROL
SHAFT
SHIFT CABLE
COVER
8 x 1.25 mm
18 N.m (1.8 kg-m ,
13 lb-ftl
0 x 1.0 nvn
12 N.m (1.2 kg-m ,9 lb-ft)
13. Install the right radius rod and damper fork.
NOTE:
Check for dotsrioration or damage of the radius rod
rubber bushings.
SELF.LOCKING NUT
1 2 x 1 . 2 5 m m
DAMPEB PINCH BOLT
1O x 1.25 ftm
44 N.m (4.4 kem,32 b-tr)
Roplace.
55 N.m {5.5 kg-m ,40 b-ft}
R6place.
RUBBER
BUS}IINGS
RADIUS ROD
{cont'dl
l2 x 1.25 mm
105 N.m (10.5 kgFm .76 lb-ft)
Roplaco.
14 - 1 3 9