Stall Speed - Honda Prelude 1993 Service Manual

Hide thumbs Also See for Prelude 1993:

Table of Contents

. To provont tlansmission damago, do not t6st stall spood for mors than 1O locond! at r tlma,

. Do not shlft tho lovel whlle lalsing tha engine speed.

. 86 suro lo romovo the prossure gaugo befolo testlng stal spood.

1. Eng€ge parking brake and block the front wheels.

Connect tachometer. and sta.t the engine.

3. Make sure the A/C switch is OFF.

After the engine has warmed up to normal operating tempersture (the rad;8tor tan comes on), shift into @ Ooshion.

5. Fully depress the brake pedal and accelerator for 6 to 8 seconds, and note engins sp€ed,

6. Allow 2 minutes for coolins, then repeat the test in loil, [Tl , ana [_] oositions.

. St8llspeed rests should be used lor diasfEtiplqrpos€s only.

. Stall speed should be the same in

L91l , L?l , L1l and L!_l positions.

Stall Soeed RPM:

F22Al Engin€

Spoclficatlon:

Sarvice Limit:

H23Al Engino

Sp€cification:

Service Limit:

2,60O-2,90O rpm

PROBAELE CAUSE

starlrpm hish i" F;] ,E .E -o E

Low fluid levelor oil pump output

Clogged ATF strsiner

Pressure r€gulstol vafue stuck clossd

Slipping clutch

Stall rom hioh in @ nosition

Slippage ol 4th clutch

Stall rom hieh in @ and @

Slippage of 2nd clutch

Stall rpm hish in E

Slippage of 1st clutch or lst gesr one-way clutch

stallrpm low i" [D;l .E

Engine output low

Torque converter one-way clutch slipping

Troubleshooting