Honda Prelude 1993 Service Manual page 1356

Cruise Control
Set/Resume Switch Test/Replacement
CAUTION:
a All SRS €lectrical wiring halnesses ar€ covorad wlth
yellow outer inaulation.
a Botoro disconnecting tho SRS wire harness, install
the 6hon connector(sl on th€ airbag(s) (sea page
23-2941.
a Replaco the €ntire affected SRS harnass assembly if
it has an op€n circuit or damaged wiring.
NOTE: The radio may have a coded theft protection cir-
cuit. Be sure to get the customer's code number before
- Disconnecting the battery.
Removing the No. 43 (1O A) fuse.
(ln the under-hood fuse/relay box)
- Removing the radio.
After service, reconnect power to the .adio and turn it
o n .
When the word "CODE" is displayed. enter the
customer's 5-digit code to restore radio oDeration.
Disconnect the battery negative cable. and then
positive cable.
Make sure the wheels are turned straight ahead.
Remove the two screws and access Danel, then
remove the short connector from the access Danel.
Disconnect the airbag connector from the cable
reel connector.
4 .
23-278
5. Installthe short connectof on the airbag connector.
CABLE REEL
CONNECTOR
AIR BAG
CONNECTOF
SHORT
CONNECTOR
(RED}
ACCESS PANEL
o .
Remove the dashboard lower cover and knee
bolster,
Disconnect the cable reel 6-p connector from the
SRS main harness, then connect Test Harness C
only to the cable reel side ot the 6-p connector.