Honda Prelude 1993 Service Manual page 1276

Side Marker/Turn Signal/Hazard Flasher System
Turn Signal/Hazard Relay Input Test
CAUTION:
a All SRS electrical wlring harnessos are covared with
yollow outor insulation,
a When disconnecting tho SRS wiro harness. inslall
th€ short connectol on tho airbag(s). lhsn discon-
noct the wiro ha.ness (soo page 23-294).
a Replac€ the €ntiro aft6ct6d SRS hamess ass€mbly it
it has is an open circuit or damagod wlring,
Remove the driver's side kick panel. then remove
the turn signal/hazard relay from the under-dash
fuse/relay box.
Inspect the socket terminals to be sure they are all
making good contact.
a lJ the terminals are bent, loose, or corroded,
repair them as necessary, and recheck the
sysrem.
a lf the terminals look OK, make the following in-
put tests at the socket.
- lJ a test indicates a problem, find and correct
the cause, then recheck the system.
- lf all the input tests provB OK, the turn
signal/hazard relay must be faulty; replace it.
lerminal side
1 2 3
9 e e
aEo
4 5 6
2 3 - 1 9 8