Honda Prelude 1993 Service Manual page 722

On-Car Checks
Rack Guide Adjustment {cont'd)
4WS:
'1. Remove the gearbox shield.
2. Cut wire tie trom the cover, then remove the cover
from the front sub steering angle sensor,
CAUTION: Cut the wire tie with carefullv, so as
not to damago the harness.
SENSOR WIRE HARNESS
cot{t{EcToR
COVER
FRONT SUB STEERING ANGLE SENSOR
3. Remove the sub steering angle sensor wire harness
from the clamD and disconnect the connector.
4. Loosen the rack guide screw locknut with the
special tool.
5. Tlghten. loosen and retighten the rack guide screw
two times to 4 N.m (O.4 kg-m, 2,9 ib-ft) then back
it olf 20
*
!'.
6. Tighten the locknut to about 25 N.m (2.5 kg-m,
18 lb-ft) while holding the rack guide screw.
7. Check for tight or loose steering through the com-
plete turning travel.
8. Recheck steering assist (see page l7-79i.
zo .3'
LOCKNUT WRENCH, 43 mm
07MAA-S10020A
RACK GUIDE SCREW
LOCKNUT
RACK GUIDE SCR€W
9. Reconnect the connector and secure the sensor
wire harness with the clamp and install the cover.
NOTE:
a Be sure the sensor wire harness dois not in-
terfere with the stabilizer and other moving
parts.
a Be certain that the sensor wire harness is not
twisted before connecting it.
1O. Set the cover on the tront sub steerang angle sen-
sor. Secure the cover with the new wire tie.
NOTE: After rack guide adjustment, perform the
electrical check on the 4WS system (see page
1 7 - 1 4 6 ) .
17-76