Honda Prelude 1993 Service Manual page 734

Steering Wheel
lnstallation {cont'd)
9. Insert the cruise control set/resume switches con-
nector to the steering wheel clips.
Connect the horn connector'
10. Install the driver's airbag assembly with new
TORX@ bolts.
BOLT
TORXO EOLT
10 N.m 11.0 kg-m, 7 lb-ftl
10 N.m {1.O kg-m
7 rb-ft1
SET/RESUME SWITCHES
ORIVER'S AIREAG ASSEMBLY
17-88
1 1 . D i s c o n n e c t t h e s h o r t c o n n e c t o r ( R E D ) f r o m t h e a i r
bag connecror.
'12.
Connect the airbag connector and cable reel
connector.
13. Attach the short connector (RED) on the access
panel, and install the access panel on the steering
lower cover.
IREDI
14. Connect the battery positive terminal and then con
nect the negative terminal,
15. After installing the driver's airbag assemblY, con
lirm ProPer sYstem oPeration:
a Turn the ignition to ll positionl the instrument
panel SRS indicator light should come on for
about six seconds and then go off.
a Confirm operation of horn buttons.
a Contirm operation ot cruise control set/resume
switches.
a Turn the steering wheel counterclockwise and
make sure the yellow gear tooth still lines up
with the alignment mark.